ICOM AP-3 사용자 설명서

PANEL DESCRIPTION

2

7

Connect the AC adapter (BC-123A) to this jack. Be sure
the ferrite core (

☞

p. 9) is attached to the AC adapter

cord.

r

Connect a grounding wire to this terminal.
Use a commercially available grounding wire. 

t

This button is used to put the AP-3 unit into [Utility Use
Data Update Mode], which is the mode used for using the
Utility to update the firmware or initialize the setting data. 
* See “12 Utility Software” (

☞

p. 67) for instructions

regarding how to operate the Utility. 

y

This button is used to put the AP-3 unit into [Setting
Initialization Mode], which is a mode used for initializing
the setting data to the original factory settings. 
* See “10 Setting Data Initialization” (

☞

p. 63) for instruc-

tions regarding how to use [Setting Initialization Mode]
mode.

u

This button is used to restart the AP-3 unit (i.e. initialize
its hardware).
* The result is the same as turning off the power and turn-

ing it back on.

i

This is an RJ-45 type Ethernet port.
Connect a computer or a hub to the AP-3 unit using the
provided Ethernet cable (straight cable). 
* This port can also be used for 100BASE-TX (high-

speed wired LAN) communications.

* Use a Class 5 cable (such as the provided Ethernet

cable) or higher level cable when conducting 100BASE-
TX communications. Avoid lower grade cables.

If a lower grade of cable is used, the grade of the entire
network will be pulled down to the same level.

* If the [LAN] lamp does not illuminate when the power is

on and the AP-3 unit is connected to the wired LAN,
change the setting of the [HUB/PC] switch (

☞

p. 8).

·············································Continued on following page

o