ICOM AP-3 사용자 설명서
AP-3 SETTINGS
6
37
6-1 Before Getting Started
Disconnect the network computers from the AP-3 unit
if you are starting up the AP-3 unit for the first time
after purchasing it or after initializing all setting data.
Connect only the computer than will be used for to
adjust the settings. The connection can be wired or
wireless.
if you are starting up the AP-3 unit for the first time
after purchasing it or after initializing all setting data.
Connect only the computer than will be used for to
adjust the settings. The connection can be wired or
wireless.
If the AP-3 unit is connected to a working network with-
out changing the original factory settings, IP address
conflicts and other network problems may occur.
out changing the original factory settings, IP address
conflicts and other network problems may occur.
6-2 Preparing to Adjust the Settings with a Cable Connection
Å
Connections
See “4-1 Connecting to a Computer” (
☞
p. 14) regarding
how to connect the computer to the AP-3.
Setting terminal
AP-3
Ethernet cable
ı
Starting the AP-3
and computer
and computer
1. After connecting the cable, connect the provided AC
adapter to the DC jack of the AP-3 and plug it into an
outlet. The AP-3 unit will power on. (
outlet. The AP-3 unit will power on. (
☞
section 4-3, p.
16)
• At first all lamps on the front panel will illuminate, then
only the [POWER] lamp will remain on.
2. Start up the computer.
• If the connection is established normally, the [LAN]
lamp (
☞
p. 6) on the front panel of the AP-3 will illu-
minate.
* If the [LAN] lamp does not illuminate set the
[HUB/PC] switch to [PC]. (
☞
pp. 6 and 14)
[IMPORTANT]
When the computer is connected to the AP-3 through a hub, do not
start up any computer other than the computer being used to adjust
the settings (setting terminal) until the settings are completed.
When the computer is connected to the AP-3 through a hub, do not
start up any computer other than the computer being used to adjust
the settings (setting terminal) until the settings are completed.
[NOTE]
If possible, use a cable connection between the AP-3 and the com-
puter used to adjust the settings.
If possible, use a cable connection between the AP-3 and the com-
puter used to adjust the settings.