Mitek AWMC3 사용자 설명서
M T X . C O M
4
INSTALLATION
Mounting (Using Mounting Plate)
To mount the unit, find a flat surface with adequate clearance behind it that provides enough room for
the unit and all it’s necessary wiring.
• Once a mounting location has been determined, cut a circular hole 3" (77mm) in diameter.
• After the hole is cut, slide the unit and wiring through the hole. A piece of self adhesive EVA foam
is supplied in order to create a water resistant seal. This may be placed on the back side of the
unit if desired.
• Slide the mounting plate over the backside of the unit and secure with the supplied screws.
• Press on the trim bezel to the front side of the unit.
• Plug in all wiring harnesses and cables. Refer to the wiring diagram for wire harness connection
types.
Mounting (Using U Shape Bracket)
To mount the unit, find a flat surface with adequate clearance behind it that provides enough room for
the unit and all it’s necessary wiring.
• Once a mounting location has been determined, cut a circular hole 3" (77mm) in diameter.
• After the hole is cut, slide the unit and wiring through the hole. A piece of self adhesive EVA foam
is supplied in order to create a water resistant seal. This may be placed on the back side of the
unit if desired.
• Slide the U bracket over the two studs on the back of the unit. Tighten down with supplied nuts.
• Press on the trim bezel to the front side of the unit.
• Plug in all wiring harnesses and cables. Refer to the wiring diagram for wire harness connection
types.
Trim Bezel
Panel
Nuts
U Shape Bracket
Source Unit
Mounting Plate
Source Unit
Trim Bezel
Mounting Screws
Panel
Trim Bezel
Panel
Nuts
U Shape Bracket
Source Unit
Mounting Plate
Source Unit
Trim Bezel
Mounting Screws
Panel
MTX005460D AWMC3 Owners Manual.indd 4
3/30/17 1:45 PM