Intel Corporation ND1 사용자 설명서
Overview
Intel® Edison
September 2014
Quick Start Guide
Document Number: EQSG-ww29
Intel Confidential
7
2
Overview
Thank you for participating in the Intel® Edison development program. Your development pacakge includes an Intel®
Edison development (daughter) board and an Arduino expansion board (Figure 1). This figure also shows some of
the key components on the Intel® Edison development board that you might need to access for the purposes of this
document.
Edison development (daughter) board and an Arduino expansion board (Figure 1). This figure also shows some of
the key components on the Intel® Edison development board that you might need to access for the purposes of this
document.
Figure 1
What’s included in the box
FW - Firmware
recover (connected
to pin #63)
recover (connected
to pin #63)
Micro SD card slot
Arduino expansion board
RM button
(Recovery
Mode;
connected to
pin #30)
Power
Intel® Edison
board
board
Micro
USB port
(for
flashing)
USB port
(for
flashing)
Serial port
You will also need the following (not included):
•
One microUSB cable (two, if you want to use both microUSB ports simultaneously)
•
One power supply, with a 2.1 mm center-positive jack, that provides voltage between 7 and 15 V.
The Intel® Edison development board can be powered over USB (max 0.5 A) through the USB multigadget port and
by an external power supply that provides between 7 and 15 V.
by an external power supply that provides between 7 and 15 V.
The UART port is the debug port and provides a serial connection to the Edison board.
The multigadget port is a USB CDC device that does multiple things on the same connection:
•
Can power the Edison board.
•
Provides a network interface through remote network driver interface specification (RNDIS).
•
Provides a serial connection and access for Arduino IDE through ACM serial.
•
Grants the host computer access to an 800 MB Edison partition as a USB drive.
•
Allows users to flash the Edison device.
The USB 2.0 Host port allows USB devices, such as cameras, to connect to the Edison. This port cannot be used at
the same time as the multigadget port; you must use the micro switch to enable one or the other.
the same time as the multigadget port; you must use the micro switch to enable one or the other.