GODOX PHOTO EQUIPMENT CO.LTD V350 사용자 설명서

Long Press the <SYNC> 

1

button for 2 seconds so that  
<     > is blinking. Turn the 
Select Dial until the <        > is 
displayed on the LCD panel, 
which means the slave unit. 

Press the <SLAVE> Button to 

1

c h o o s e   t h e   g r o u p   f r o m  
M/A/B/C.  Then,  press  the 
<  MODE  >  Button  so  that  the 
master unit can work in OFF / 
TTL  /  M  flash  mode.  Choose 
one  of  them  as  the  flash 
mode of master unit.

If there are other wireless flash systems nearby, you can change the 
channel  IDs  to  prevent  signal  interference.  The  channel  IDs  of  the 
master unit and the slave unit(s) must be set to the same.

Long press the <SLAVE> 

1

Button for 2 seconds until the 
channel IDs is blinking. Turn 
the Select Dial to choose a 
channel ID from 1 to 16.

Press the <SET> button to 

2

confirm.

Press the <MODE> Button for 

2

2 seconds to switch to Multi 
mode.

2

● Set the V350S that to be  
   controlled as the wireless 

  

   slave unit. (Page 41)

    

     ● The slave unit can be set 

            as A/B/C. 

3

channel
● If the master unit and 
   slave unit(s) are set to a 
   different channel, set them 
   to the same channel. 
   (Page 41)

4

● Position the camera and 
   flashes as the picture 
   shows. (Page 43)

5

● Press the master unit’s  

   Test Button<    >

.

          ● Then, the slave unit will 
             fire. If not, adjust the slave 
             unit’s angle toward the 
             master unit and distance 
             from the master unit.

The slave unit might be out of order or fire an unwanted flash 
due to the nearby wifi routers or other 2.4G equipments. If in 
this case, please adjust the flash’s channel or turn off the 2.4G 
equipments.

1

● Attach a V350S camera 
flash on the camera and set it 
as the master unit.  (Page 40)

          ● M/A/B/C can be set as 
             TTL mode independently.

-  41  -

-  42  -

Change the wireless channels and wireless ID to avoid interference 

for it can only be triggered after the wireless IDs and channels of the 

master unit and the slave unit are set to the same. 

Press the <MENU> button to enter C.Fn ID. Press the <SET> button 

to choose OFF channel expansion shutdown, and choose any figure 

from 01 to 99. 

This describes wireless (multiple shooting) using manual flash. You 
can shoot with a different flash output setting for each slave unit 
(firing group). Set all parameters on the master unit.

1

● Press the <MODE> Button 
to set the flash to M mode.
Setting flash output

2

●

 Turn the Select Dial to set 

the flash output of the 
groups.