SHENZHEN IP-COM NETWORKS CO. LTD. AP375 사용자 설명서
3
Ports and Button
PoE port
This 10/100/1000 Mbps auto-negotiation port is used to connect to a PoE power supply and
exchange data. To supply power to the AP, use an Ethernet cable to connect the AP to an injector or
a PoE switch compliant with the IEEE 802.3at standard.
exchange data. To supply power to the AP, use an Ethernet cable to connect the AP to an injector or
a PoE switch compliant with the IEEE 802.3at standard.
LAN port
This 10/100/1000 Mbps auto-negotiation port is used to connect to switches, computers and other
devices.
devices.
Reset button
After the AP is powered on, you can hold down this button for 7 seconds to restore the factory
settings.
settings.
Label
It is attached to the rear panel of the AP. The following figure shows its position.
8KYKZH[ZZUT
PoE
VUXZ
LAN port