Cyrus Audio Ltd. JG12 사용자 설명서
Cyrus Pre
DAC
User Instructions
21
TROUblEShOOTINg gUIDE
If your amplifier is not operating properly, disconnect the
power and check carefully all connections.
If you are in any doubt, consult your retailer.
If you are in any doubt, consult your retailer.
No sound
The amplifier is switched
The amplifier is switched
off or in Standby
Bring the unit out of
standby
(Standby light - GREEN)
(Standby light - GREEN)
Mute is on
deselect Mute
The source is not working
(e.g. CD not playing or
paused)
Check the source
The power amplifier may
not be switched on.
Check that the power
amplifier is switched on.
No sound (digital sources)
The sample rate or sound
The sample rate or sound
format of the digital signal
from the source may not
be correct.
Check that the sample
rate from the source is
within the specification of
the amplifier and that the
program is encoded as two
channel stereo.
No sound from one loudspeaker
bAl control at extreme
bAl control at extreme
limit
Centralise balance
Does your speaker have
fuses?
Check speaker, replace
fuses
Speaker cables /
interconnects faulty
Check connections, cables -
replace if needed
Spurious noises from speakers
Interconnects or
Interconnects or
connections faulty
Check, replace where
necessary
Only one digital source is selectable for Zone 2
If a digital input is selected for the main system, then this
If a digital input is selected for the main system, then this
will be the only digital source selectable for Zone 2. If an
analogue source is playing in the main system, then all
digital sources will be selectable for Zone 2.
Remote control not working
Remote control not
Remote control not working
Remote control not
operating
Check batteries