Mesh Systems LLC DS003 사용자 설명서
P a g e
| 12
Version 1.0
DOW CONFIDENTIAL - Do not share without permission
Figure 4: Hub Initialization
Should the light schema not match this picture:
If signal strength is too low, relocate the hub
If the light schema is still not in the desired state, unplug the hub. Wait for all lights to turn off
(about 10 minutes), then plug the device back into a power outlet.
(about 10 minutes), then plug the device back into a power outlet.
Contact your ActiveSense Specialist if this schema is not achieved.
Warning: Under normal installation processes, the blue set/reset button on the back of the hub is
not needed. This should be used under an ActiveSense Specialist supervision only. Functions performed:
Clears Hub memory of all devices (press and hold for 10 seconds)
Hub Icons
Description
Signal: Green indicates signal strength to the cellular network. Three bars are optimal, but
two are acceptable.
two are acceptable.
If only one bar is displayed, the Hub should be relocated.
Connect: Flashing blue indicates the Hub is in installation mode and ready to accept new
Sensors and Range Extenders.
Sensors and Range Extenders.
Cloud: Green indicates the Hub is communicating with the cloud. A short flash of blue or
white indicates the Hub has sent or received a message.
white indicates the Hub has sent or received a message.
Power: Green indicates the device is powered.