Bombardier Transportation JGA29001-6 사용자 설명서
Doc.Id:
Status:
RELEASED
Version:
1.0
© 2014, Bombardier Inc. or its subsidiaries.
Confidential and proprietary.
Filename: JGA29001-6UserMan.docx
Page 7 of 15
1DOC-1001388
2.3 Programming of Transponder
The transponder must be programmed with a default telegram, according to the
projecting documentation. The transponder is programmed with an all zero
telegram when manufactured.
projecting documentation. The transponder is programmed with an all zero
telegram when manufactured.
The default telegram is to be established during the wayside projecting.
Note: Direct after that the transponder is programmed; the protection cup must
be properly attached to the transponder connector
be properly attached to the transponder connector
2.4 Location of Transponders
2.4.1 Mounting location
2.4.1.1 General
Normally transponders should be located within an attenuation free area.
No metal objects except for reinforcing iron in the crosstie and mounting bolts
may be within the shaded area according to figure below.
may be within the shaded area according to figure below.
Unobstructed space must surround the transponder so that information can be
transmitted without disturbances.
transmitted without disturbances.
If these conditions are not fulfilled a transponder fault can occur as a result of
disturbances in the transmission between the vehicle and the transponder.
disturbances in the transmission between the vehicle and the transponder.
NOTE:
Deviations from these requirements are absolutely forbidden without written
permission from Bombardier.
Deviations from these requirements are absolutely forbidden without written
permission from Bombardier.