Eno Scientific LLC WS600A 사용자 설명서
ALARM – Enables the High or Low Alarm. The options are:
None to keep the output at 0v,
Low to set the output to 5v when the water level reaches the deep set point,
High to set the output to 5v when the water level reaches a shallow set point.
Both so that the ouput will be 0v when the water level is between the high
Low to set the output to 5v when the water level reaches the deep set point,
High to set the output to 5v when the water level reaches a shallow set point.
Both so that the ouput will be 0v when the water level is between the high
and low set points and 5v otherwise.
ALARM HIGH SETPOINT/ ALARM LOW SETPOINT – these screens are added to the
set screens when the Alarm feature is activated. Press the UP or DOWN button to
select the set points for the alarm. So for example, if Alarm Low is selected and the low
set point is set to 150, then the output level will be 0 volts when the depth is less than
150, and it will be 5 volts when the depth is 150 or more.
set screens when the Alarm feature is activated. Press the UP or DOWN button to
select the set points for the alarm. So for example, if Alarm Low is selected and the low
set point is set to 150, then the output level will be 0 volts when the depth is less than
150, and it will be 5 volts when the depth is 150 or more.
UNITS – selects the measurement system for the data. Press the UP or DOWN button
to scroll through the options: English for decimal feet, degrees Fahrenheit and gallons;
English ft-in for distance displayed as feet and inches; Metric for meters, degrees
Celsius, and liters, or Imperial for feet, degrees Fahrenheit and imperial gallons.
to scroll through the options: English for decimal feet, degrees Fahrenheit and gallons;
English ft-in for distance displayed as feet and inches; Metric for meters, degrees
Celsius, and liters, or Imperial for feet, degrees Fahrenheit and imperial gallons.
CONTRAST - sets the contrast level on the LCD screen from 0 (brightest) to 20
(dimmest).
(dimmest).
SAVE SETTINGS – settings changed on the set screens will remain until the power is
turned off, unless they are saved. Press ENTER on this screen to make the current
settings the power on defaults.
turned off, unless they are saved. Press ENTER on this screen to make the current
settings the power on defaults.
FACTORY RESET – allows the user return the unit to the factory default configuration.
Press the ENTER button to make the selection. All user settings will be set to the
Factory default values.
Press the ENTER button to make the selection. All user settings will be set to the
Factory default values.
LOGGING
The Well Watch 660DL includes a built-in data logger which can record the
measurement data automatically at preset intervals when automatic logging is enabled.
Each data point includes the system time and date, well ID, depth, temperature, battery
voltage, signal strength, and error codes. The data is recorded in the internal flash
memory which maintains the data even if the battery goes dead. The internal memory
is large enough to hold more than 25 million data points. This memory is only
accessible using the USB interface as described in the next section.
measurement data automatically at preset intervals when automatic logging is enabled.
Each data point includes the system time and date, well ID, depth, temperature, battery
voltage, signal strength, and error codes. The data is recorded in the internal flash
memory which maintains the data even if the battery goes dead. The internal memory
is large enough to hold more than 25 million data points. This memory is only
accessible using the USB interface as described in the next section.
Eno Scientific Well Watch 660DL
Page 20