Eno Scientific LLC WS600A 사용자 설명서

다운로드
페이지 40
FREQUENTLY ASKED QUESTIONS
Q: Can I use the Well Watch on an open well?
A: The Well Watch was designed to work on a closed well. A simple piece of rigid card 
board or plastic held tight against the opening is enough to meet this requirement. In 
many cases it will work on the open well but may be off by a couple feet.
Q: Does the Well Watch work on wells with the pump installed?
A: Yes. The sound pulse used for measuring is not disturbed by the presence on pump 
wiring or piping. 
Q: What if there are guard rings or torque arresters on the pump line?
A: The Well Watch will read past most guard rings and torque arresters with little signal 
attenuation. Some torque arresters may block more than 90% of the well opening and 
may cause problems.
Q: Will the Well Watch work with the pump running?
A: Generally, yes. If however the pump is exceptionally noisy and or the water level is 
near or below the pump, it is possible that the noise from the pump could interfere with 
the depth measurement.
Q: Does the Well Watch work on larger diameter wells?
A: The Well Watch, with the standard probe, works on wells up to 18” in diameter. 
However, as the well diameter increases, the signal strength weakens and becomes 
more susceptible to pump noise and imperfections in the well. It is recommended that 
on wells larger than 8” that a sounding tube be used.
Q: How deep will the Well Watch measure?
A: The maximum range is 2000 feet. This may not be achievable on all wells however. 
On a good 6” well with tight clean casing all the way down to the water and little or no 
obstructions along the way, maximum range can be achieved. On uncased wells drilled 
through porous stone or with irregular walls, or any obstructions such as spacer rings 
or couplings the range will be reduced.
Q: Does the Well Watch work in wells with perforated casing?
A: If the perforations are exposed (above the water line) and the exterior of the casing 
is very porous like crushed stone, then the perforations will dampen the sound pulse 
and there will be no reflection for the Well Watch to detect. In this case, the Well Watch 
will track the descending water level until it gets to the perforations and then stick at the 
start of the exposed perforations as the water level continues to descend.
 
  Eno Scientific  Well Watch 660DL
Page 29