Ulterius Technologies LLC FDN40 사용자 설명서
CHAPTER 13: NTP
Configuration User Manual
251
© Ulterius Technologies, LLC 2016. Confidential & Proprietary.
13.5 NTP Configurations
13.5.1 Configuring NTP system
13.5.1.1 Enabling the NTP system
1. Execute the following commands to enable NTP on the target.
Enabling the NTP module is a two step configuration
First enable NTP mode and then enabling client mode and further user
configuration of server and polltime
configuration of server and polltime
Enter the Global Configuration Mode.
UltOs# configure terminal
Enter NTP config mode.
UltOs(config)# ntp
Enable NTP mode
UltOs(config-ntp)# set ntp enable
Enable NTP client mode unicast
set ntp client mode {unicast | multicast | disabled}
UltOs(config-ntp)# set ntp client mode unicast
User can now configure IP and polltime in unicast mode
UltOs(config-ntp)# exit
2. View the NTP related global information.
UltOs# show ntp mode
NTP SERVICE ENABLE CONFIGURATION:
NTP SERVICE ENABLE : ENABLED
UltOs# show ntp client mode
NTP SERVCIE CONFIGURATION INFORMATION:
NTP CLIENT MODE : UNICAST
UltOs# show ntp server
NTP SERVER INFO :
Server Address: 172.30.19.172
Polltime: 6
NTP SERVER INFO :
Server Address: 172.30.19.123
Polltime: 6
13.5.1.2 Disabling the NTP system
1. Execute the following commands to disable NTP on the target.
Enter the Global Configuration Mode.
UltOs# configure terminal