Ulterius Technologies LLC FDN40 사용자 설명서
CHAPTER 15: OSPF
`FDN40ConfigUM/20160505
291
© Ulterius Technologies, LLC 2016. Confidential & Proprietary.
- Enable simple password authentication.
UltOs(config-if)# ip ospf authentication
- Exit from the Interface Configuration mode.
UltOs(config-if)# exit
- Exit from the configuration mode.
UltOs(config)# exit
UltOs#
2.View the authentication type configured by executing the following show
command.
command.
UltOs# show ip ospf interface
vlan11 is line protocol is up
vlan11 is line protocol is up
Internet Address 10.4.0.2, Mask 255.255.0.0, Area 0.0.0.0
AS 1, Router ID 10.4.0.2, Network Type BROADCAST, Cost 1
Transmit Delay is 1 sec, State 5, Priority 1
Designated RouterId 10.4.0.4, Interface address 10.4.0.4
Backup Designated RouterId 10.4.0.2, Interface address 10.4.0.2
Timer intervals configured, Hello 10, Dead 40, Wait 40, Retransmit 5
Hello due in 0 sec
Neighbor Count is 1, Adjacent neighbor count is 1
Adjacent with the neighbor 10.4.0.4
Simple password authentication enabled
3.View the adjacency formed between the neighbors (FDN40-2 and FDN40-4)
by executing the following command.
by executing the following command.
UltOs# show ip ospf neighbor detail
Neighbor 10.4.0.4, interface address 10.4.0.4
In the area 0.0.0.0 via interface vlan11
Neighbor priority is 1, State is FULL/BACKUP, 5 state changes
DR is 10.4.0.4 BDR is 10.4.0.2
Options is 0x2
A previously assigned OSPF password can be removed by executing the
following command. UltOs(config-if)# no ip ospf authentication-key
15.5.11.1.2
WEB Configuration
OSPF Simple Password Authentication can be configured through WEB
interface using the OSPF Interface screen. For screenshot, refer section
4.5.3.2.
interface using the OSPF Interface screen. For screenshot, refer section
4.5.3.2.
A previously assigned OSPF password can be removed by executing the
following command. UltOs(config-if)# no ip ospf authentication-key