Ulterius Technologies LLC FDN40 사용자 설명서
CHAPTER 4: RIP
Configuration User Manual
82
© Ulterius Technologies, LLC 2016. Confidential & Proprietary.
Invalid after 180 seconds
Flushed after 120 seconds
Send version is 1 2, receive version is 1 2
Authentication type is none
Split Horizon with poissoned reverse is enabled
Restrcts default route installation
Restricts default route origination
4.5.4.2
WEB Configuration
RIP retransmission interval and maximum retries count can be configured
through WEB interface using the RIP Basic Settings screen. For
screenshot, refer section 4.5.3.2.
through WEB interface using the RIP Basic Settings screen. For
screenshot, refer section 4.5.3.2.
4.5.5
Configuring RIP Neighbor
Refer the Section 4.3 for configuration guidelines and Figure 4-2 for the
Setup. The prerequisite configuration needs to be done in the switches
(FDN40-1, FDN40-2 and FDN40-3 ) before configuring RIP.
Setup. The prerequisite configuration needs to be done in the switches
(FDN40-1, FDN40-2 and FDN40-3 ) before configuring RIP.
4.5.5.1
CLI Configuration
Execute the following commands in the switch FDN40-1 to configure the RIP
neighbor.
neighbor.
Enter the Global Configuration mode.
UltOs# configure terminal
Enable RIP globally in the switch FDN40-1.
UltOs(config)# router rip
Enable RIP over the interface vlan 1 (IP address 10.0.0.1/16)
UltOs(config-router)# network 10.0.0.1
Configure the RIP trusted neighbor.
UltOs(config-router)# neighbor 10.0.0.2
In FDN40-1, you can view only the routes that are sent as RIP
updates from the neighbor router FDN40-2 (10.0.0.2) .
updates from the neighbor router FDN40-2 (10.0.0.2) .
Delete the configured RIP neighbor.
UltOs(config-router)# no neighbor 10.0.0.2
In FDN40-1, you can view the routes that are sent as RIP updates
from both the neighbor routers FDN40-2 (10.0.0.2) and FDN40-
3.(10.0.0.3).
from both the neighbor routers FDN40-2 (10.0.0.2) and FDN40-
3.(10.0.0.3).
Exit from the router configuration mode.
UltOs(config-router)# exit