elco S5160Q4G 사용자 설명서
Poor signal.
Please move to a place
with a bette r signal and
try again.
Unable to make a
call
Using the call bar function
Cancel the call bar
function.
Using the fixed dialling function.
Cancel the fixed call
setting.
Incorrect PIN
number
Consecutively enter the wron
g
password three times.
Contact your network
provider.
Unable to charge
Battery or charger is damaged
Replace the battery or
charger.
Recharging in the envir onment of
less than -10
℃
or higher than
45℃.extreme tempera tures can
cause defor mation of mobile pho ne,
reduce the charging cap acity and
shorten the service life o f the battery
and the mobile phone .
Change the charging
environment.
Poor contact
Check if
the plug is
properly connected
Unable to add new
phone book entries
The storage space of the phone book
is full
Delete a po rtion of the
phone number entries
Unable to set certain
functions
Your netwo rk provider does not
support this function or y ou have no t
applied for it.
Contact your network
provider.
Warning:
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
compliance could void the user's authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the