Alinket Electronic Technology Co. Ltd. ALXCOMBA 사용자 설명서
ALXC2X DATASHEET
E-mail:
sales@alinket.com
Website:
http://www.alinket.com
22
-
OTG
On-The-Go
-
PER
Packet Error Rate
-
PLL
Phase Locked Logic
-
PMU
Phasor Measurement Unit
-
PWM
Pulse Width Modulation
-
RC
Real Clock
-
RTC
Real Time Clock
-
RF
Radio Frequency
-
ROHS
Restriction of Hazardous Substances
-
SKU
Stock Keeping Unit
-
SPI
Serial Peripheral Interface
-
SRAM
Static Random Access Memory
-
SRP
Session Request Protocol
-
TLS
Transport Layer Security
-
TCP
Transmission Control Protocol
-
TKIP
Temporal Key Integrity Protocol
-
USBH
Universal Serial Bus Host Mode
-
USBD
Universal Serial Bus Device Mode
-
UDP
User Datagram Protocol
-
UART
universal asynchronous receiver/transmitter
-
WAPI
WLAN Authentication and Privacy Infrastructure
-
WiFi
Wireless Fidelity
-
WLAN
Wireless Local Area Network
-
WPA
Wi-Fi Protected Access
Notice:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
To satisfy FCC RF Exposure requirements for this transmission devices, a separation distance of 20cm
or more should be maintained between the antenna of this device and persons during operation. To
ensure compliance, operation at closer than this distance is not recommended. The antenna(s) used
for this transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter. Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
The modular transmitter must be equipped with either a permanently affixed label or must be
capable of electronically displaying its FCC identification number：
or more should be maintained between the antenna of this device and persons during operation. To
ensure compliance, operation at closer than this distance is not recommended. The antenna(s) used
for this transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter. Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
The modular transmitter must be equipped with either a permanently affixed label or must be
capable of electronically displaying its FCC identification number：
(A) If using a permanently affixed label, the modular transmitter must be labeled with its own FCC
identification number, and, if the FCC identification number is not visible when the module is installed
inside another device, then the outside of the device into which the module is installed must also
display a label referring to the enclosed module. This exterior label can use wording such as the
following: “Contains Transmitter Module FCC ID:2AELJ-ALXCOMBA.” Any similar wording that
expresses the same meaning may be used. The Grantee may either provide such a label, an example
of which must be included in the application for equipment authorization, or, must provide adequate
instructions along with the module which explain this requirement. In the latter case, a copy of these
instructions must be included in the application for equipment authorization.
identification number, and, if the FCC identification number is not visible when the module is installed
inside another device, then the outside of the device into which the module is installed must also
display a label referring to the enclosed module. This exterior label can use wording such as the
following: “Contains Transmitter Module FCC ID:2AELJ-ALXCOMBA.” Any similar wording that
expresses the same meaning may be used. The Grantee may either provide such a label, an example
of which must be included in the application for equipment authorization, or, must provide adequate
instructions along with the module which explain this requirement. In the latter case, a copy of these
instructions must be included in the application for equipment authorization.