Quest Technical Sales and Marketing Inc. QTS0000LINK 사용자 설명서
SCREENLOGIC
®
INTERFACE Wireless Connection Kit Installation Guide
WARNING Switch OFF the main power to the Load Center
before making any connections.
1.
Switch OFF the AC power to the enclosure at the main house panel
circuit breaker.
circuit breaker.
2.
Unlatch the front door latch and open the front door. Remove the two
retaining screws from the High-Voltage Cover Panel and remove the
panel.
retaining screws from the High-Voltage Cover Panel and remove the
panel.
3.
Loosen the two retaining screws securing from the top edge of the
Outdoor Control Panel. Fold down the Outdoor Control Panel to
access the circuit board sockets connectors for the electrical
connections. Remove the panel from the enclosure (see illustration
below).
Outdoor Control Panel. Fold down the Outdoor Control Panel to
access the circuit board sockets connectors for the electrical
connections. Remove the panel from the enclosure (see illustration
below).
4.
Route the four conductor transceiver connection cable into the lower
plastic grommet, up through the low voltage raceway to the system
circuit board.
plastic grommet, up through the low voltage raceway to the system
circuit board.
6
Connect the wireless transceiver communication cable to the COM
Port on automation control system circuit board
Port on automation control system circuit board
IntelliTouch
®
or EasyTouch
®
Control System Load Center
Retaining
screws
screws
HIGH -VOLTAGE
FRONT COVER
PANEL
FRONT COVER
PANEL
Outdoor
Control Panel
retaining
screw (x2)
Outdoor
transceiver
communication
cable
(connect to
COM port)
transceiver
communication
cable
(connect to
COM port)
Outdoor
Control Panel
Grommet
(under side of
Load Center
(under side of
Load Center
Inside Low
voltage
raceway
Latch