Wata Electronics Co. Ltd BHS839 사용자 설명서
1
2
3
Function
Features
1
Press button control, audio and call mode control; 250mAh li-battary;
Micro USB connection and software update.
2
Bluetooth V4.2 , support A2DP/AVRCP/HFP; Capacitance Mic
Operating instructions
User operation
system state
Key operation
function
sound
ON/Off
It will pair when switch on,
the blue LED flash quickly.
Pree MFB key
for 3s
Bluetooth On
Swithc off bluetooth
Pree MFB key
for 3s
Bluetooth Off
PLAY/PAUSE
Bluetooth connected. The LED
is breath flashing.
Pree MFB key
for 3s
PLAY/PAUSE
D
isconnected, flash slowly
Single press on
MFB key
Connect to mobile last
connected
in call, the LED breath
flashing
flashing
Single press
on MFB key
answer
ring
in call
long press on
MFB key for 2 s
reject
no
While in call,the LED breath
flashing
Single press on
MFB key
hang up
no
last song
Bluetooth connected
Double
press
“-” Key
last song
du
next song
Bluetooth connected
Double
press
“+” Key
next song
du
add sound volume
Bluetooth connected
single
press
“+” Key
low sound volume
Bluetooth connected
Single
press
“-” Key
battery charging
USB 5V IN,red LED is on, it will off when battery is full
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. This device complies with Part
15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.