Evalan BV EVAWSN-N15 사용자 설명서
1
Safety instructions – Evalan WSN Node – 04-04-2017
Evalan WSN Node
Safety instructions
WARNINGS
-
The connectors for power, DALI and switch comes with a sticker indicating respectively
“POWER”, “DALI” and “SWITCH”. The connector for Dali is blue and needs to be connected
with the connector 890-1112 from WAGO. The connectors for Power and Switch are both
grey and need to be connected with the connector 890-242 from WAGO.
“POWER”, “DALI” and “SWITCH”. The connector for Dali is blue and needs to be connected
with the connector 890-1112 from WAGO. The connectors for Power and Switch are both
grey and need to be connected with the connector 890-242 from WAGO.
-
This product shall only be connected to a Limited power source on the power connector
(grey), according to IEC 60950-1. Any external power supply used with the LCN1 shall comply
with relevant regulations and standards applicable in the country of intended use.
(grey), according to IEC 60950-1. Any external power supply used with the LCN1 shall comply
with relevant regulations and standards applicable in the country of intended use.
-
The DALI connector shall only be connected to the DALI input of a lightning device.
Connecting any power source to the DALI connection would severely damage the product.
Connecting any power source to the DALI connection would severely damage the product.
-
This product should be operated in a well-ventilated environment, in an indoor location and
out of reach from untrained personnel. The holes of the enclosure should not be covered.
out of reach from untrained personnel. The holes of the enclosure should not be covered.
-
This product should be fixed on the metal bracket provided with the product. This metal
bracket should be properly fixed beforehand on a flat and solid surface. Make sure that the
product is properly attached to the bracket: tightly and well balanced.
bracket should be properly fixed beforehand on a flat and solid surface. Make sure that the
product is properly attached to the bracket: tightly and well balanced.
-
The connection of incompatible devices to the connectors for DALI and SWITCH may affect
compliance or result in damage to the unit and invalidate the warranty.
compliance or result in damage to the unit and invalidate the warranty.
-
This product should be positioned according to its designated position in the floor plans, to
allow a good communication with the gateways GTA-RP1.
allow a good communication with the gateways GTA-RP1.
INSTRUCTIONS FOR SAFE USE
To avoid malfunction or damage to the product please observe the following:
-
Do not expose it to water and moisture.
-
Do not expose it to heat from any source; this might affect the behavior of the temperature
sensor and the internal PCB. The maximum ambient temperature is 45°C.
sensor and the internal PCB. The maximum ambient temperature is 45°C.
-
Take care whilst handling to avoid mechanical or electrical damage to the enclosure and
internal components.
internal components.