Circuit Design Inc. NK24Y 사용자 설명서
OPERATION GUIDE
OG_NK24Y_v08e
Circuit Design, Inc.
12
Regulatory Statement for IC
Instructions to the final system integrators
The final system integrator must ensure there is no instruction provided in the user manual or customer
documentation indicating how to install or remove the transmitter module.
This module should be installed in the host device according to the interface specification.
documentation indicating how to install or remove the transmitter module.
This module should be installed in the host device according to the interface specification.
Labeling:
IC Number: 6079A-NK24Y
IC Number: 6079A-NK24Y
The proposed IC Number label format is to be placed on the module. If IC Number is not visible when the
module is installed into the system, “Contains IC: 6079A
module is installed into the system, “Contains IC: 6079A
-NK24Y” shall be placed on the outside of final
host system.
The following statements or equivalent must be described on the user manual of the host device
of this module;
of this module;
Antenna
This radio transmitter IC Number 6079A
-NK24Y has been approved by Industry Canada to operate
with the antenna types listed below with the maximum permissible gain and required antenna
impedance for each antenna type indicated. Antenna types not included in this list, having a gain
greater than the maximum gain indicated for that type, are strictly prohibited for use with this
device.
impedance for each antenna type indicated. Antenna types not included in this list, having a gain
greater than the maximum gain indicated for that type, are strictly prohibited for use with this
device.
The antenna used this module is as follows;
Antenna Type & Antenna Gain;
Antenna Type & Antenna Gain;
Sleeve Antenna (ANT-2G4S2/ANT-2G4S3) 2.14 dBi
Pattern antenna -2.0 dBi
Caution: Exposure to Radio Frequency Radiation
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment and meets RSS-102 of the IC radio frequency (RF) Exposure rules. This
equipment has very low levels of RF energy that are deemed to comply without testing of
specific absorption rate (SAR).
Cet équipement est conforme aux limites d’ exposition aux rayonnements énoncées pour un
environnement non contrôlé et respecte les règles d’ exposition aux fréquences
radioélectriques (RF) CNR-102 de l’ IC. Cet équipement émet une énergie RF très faible qui
est considérée conforme sans évaluation du débit d’ absorption spécifique (DAS).
This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the
following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage,
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne
doit pas produire de brouillage,
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.