Thomson 42" Plasma TV Hi-Pix2 42 PB 130 S5 42PB130S5 사용자 설명서

This method involves carrying out a manual search for the codes

to be used for controlling your other appliances.

Switch on the appliance you wish to use the remote control
with.

Press the relevant button for this appliance on the remote
control, and while holding this button down, enter one of the
codes relevant to your make of appliance (there is a list of
codes at the end of this manual). If the light (

 or the appliance

buttons) of the remote control flash you have entered the
wrong code or it is not possible to program the remote
control.

Point the remote control at the appliance and press the
relevant button (

,

, etc). Press the 

standby

button. If the appliance does not go into standby mode, try
another code.

Depending on the year of manufacture and the type of appliance,
some functions may not be available. Certain codes may cover
more functions than others.Test the functions you can control and,
if appropriate, try other codes. Note here the code(s) which work
best.

When you change the remote control’s batteries, remember
to reprogram it.

 Programming the volume control function

If you have programmed the TV remote control to use with other
appliances and these are connected to an amplifier you can also
programme the remote control to adjust the volume when you
are using one of these appliances.The example below describes
the procedure for programming a DVD player.

Programme the 

button on the remote control to use

with the amplifier (refer to page 4).

Move the remote control away from the appliances. Press the

button and while holding it down, press the relevant

mode button (

, in this example), then the 

button.

Release the 

button.

Switch on the amplifier, then the DVD player.

Set the remote control to 

, play a disc and adjust the

volume using the 

buttons.

Repeat this operation for the other appliances.

To cancel the programmed function for any of the appliances, press
the 

button, while holding it down and enter the code 000

using the numeric buttons.

VCR

DVD

 SAT

 AUX

 AMP

Press the VCR button.

Press the DVD button.

Press the SAT button.

Press the AMP button.

On/Standby

On/Standby

On/Standby

On/Standby

To display the main menu

To display the main menu

To display the main menu

Vertical scrolling in menus

Vertical scrolling in menus

Vertical scrolling in menus

Horizontal scrolling in menus

Horizontal scrolling in menus

Horizontal scrolling in menus

To confirm an action

To confirm an action

To confirm an action

To close a menu

To close a menu

To close a menu

To directly access channels

To enter numeric values

To directly access channels

To select a station using

or enter numeric values

or select options in menus

or enter numeric values

its number

To change channels

To change chapters

To change channels

To change stations

To select AV input

To select AV input

Rewind

Rewind

Play

Play

Fast forward

Fast forward

Stop

Stop

Pause picture

Pause picture

Record

or 

To switch the sound off and
back on again

To set the volume level

Important:
If the batteries in your remote control are run down you can use the
buttons on the front of your TV set. In TV mode, they have the same
functions as the corresponding buttons on the remote control. In the
menus they have the following functions:

œ

ƒ

‹

or 

¦

or 

To confirm a selection

IFC130-P_EN  22/11/05  9:55  Page 5