Perle S-110-M2SC2-XT 05090000 사용자 설명서
제품 코드
05090000
Perle 10/100 Ethernet Media Converter – Installation Guide
3
Installation
The default dip switch settings (all switches in the UP position) will
work for most installations.
work for most installations.
There are five steps required to configure the Perle Fast Ethernet
media converter:
media converter:
1)
Set the Auto-MDIX jumper setting (optional).
2)
Set the dip switch settings (optional).
3)
Install and connect the fiber cable.
4)
Install and connect the copper cable.
5)
Power up the media converter.
Auto-MDIX Jumper Settings
NOTE: The factory settings for Auto-MDIX will work for most
installations, but in the rare case that you need to modify the
settings, the procedure is below.
installations, but in the rare case that you need to modify the
settings, the procedure is below.
To access the Auto-MDIX jumper settings, unscrew the four side
screws on the top case and remove the cover plate. Locate the
MDIX AUTO jumper set as detailed below. By covering or
strapping pins 1 and 2, the S-110 will operate as an MDIX device.
By covering or strapping pins 2 and 3, the S-110 will automatically
detect the Ethernet cable’s polarity. Removing the strapping is the
same as AUTO.
screws on the top case and remove the cover plate. Locate the
MDIX AUTO jumper set as detailed below. By covering or
strapping pins 1 and 2, the S-110 will operate as an MDIX device.
By covering or strapping pins 2 and 3, the S-110 will automatically
detect the Ethernet cable’s polarity. Removing the strapping is the
same as AUTO.
NOTE: The default jumper setting is AUTO