Premier Mounts PSD-CS84 전단

 

Step 1 
Place the monitor on a soft and flat surface. Install the mounting bracket 
to the plasma using the hardware supplied.    
 
Step 2 
Choose the place were the stand would be located. Place the stand on 
the floor. Install the two chrome tubes on the receiving points found on 
the stand. Secure the tubes with an allen wrench. Optional shelf: Insert 
the shelf through the tubes adjust the height and lock it with the allen 
screws (supplied). Insert the ADAPP Bracket through the tubs adjust 
the height and secure with the allen wrench. Installthe  PDB-UWFB 
Universal Wall Flat Bracket (make sure that the arrow from the plate is 
facing up) to the stand by using the four (4) M10 Slotted Hex Bolts 
(supplied). 
 
Step 3 
Mount the display to the stand (2 people required). Raise the display 
and insert the openings from the mounting bracket to the slip lock 
flanges from the PDB-UWFB. Once insert push to the left and down to 
lock. 

 
 
 

Note: For ceiling or floor/ mobile carts mounting, The two (2) 6mmx12mm 
slotted jam screws may be used for additional security. The mounting hole 
is located in the back of the plate and allows the pressure against the receiving 
tabs.