Valcom Station Port VIP-810 사용자 설명서
제품 코드
VIP-810
1 947052
CAUTION: To reduce the risk of electric shock,
Do not remove cover.
No user serviceable parts inside.
Refer servicing to qualified service personnel.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
This symbol indicates that dangerous
voltage constituting a risk of electric
shock is present within this unit.
voltage constituting a risk of electric
shock is present within this unit.
This symbol indicates that there are
important operating and maintenance
instructions in the literature accompanying
this unit.
important operating and maintenance
instructions in the literature accompanying
this unit.
ISSUE 3
VIP-810
NETWORKED STATION PORT
INTRODUCTION
The VIP-810 networked station port allows most loop
start terminal devices to be connected to a managed
IP-based Local area network (LAN) or Wide area
network (WAN).
start terminal devices to be connected to a managed
IP-based Local area network (LAN) or Wide area
network (WAN).
SPECIFICATIONS
Access Methods
•
PBX, FXO Port
•
POTS telephone set
Features
•
RJ-45 for network connection
•
RJ-11 telephone connection
•
Front panel activity LED
•
Network activity LEDs on RJ-45
• 4
RENS
•
2.5mm jack for DC power (115VAC TO 24VDC
adapter provided)
adapter provided)
Dimensions/Weight
• 1.88" H x 5.50" W x 4.15" D
(4.78cm H x 13.97cm W x 10.54cm D)
(4.78cm H x 13.97cm W x 10.54cm D)
• Weight: 0.55 lbs. (0.25 kg)
Nominal Specifications
Input Impedance:
600 Ohms
Input Level:
-10dBm
Output Impedance:
600 Ohms
Output Level:
- 10dBm nominal
Nominal Power Requirements
Voltage:
24VDC
Current:
325mA
Environment
Temperature:
0 to +40°C
Humidity:
0 to 85% non-precipitating
INSTALLATION
NOTE: The telephone system referred to in this
manual is the customer premise equipment such
as an electronic key system, a PBX or a dedicated
single line telephone sets. The VIP-810 is not
intended for direct or indirect connection to the
public telephone network. When used with a
customer premise telephone system such as a
key system or PBX system, these units are
interfaced to the system via a fully protected loop
start trunk (FXO) port. Also, the host system
must be configured to disallow central office
trunk conferencing in order to prevent indirect
connection to the public network.
manual is the customer premise equipment such
as an electronic key system, a PBX or a dedicated
single line telephone sets. The VIP-810 is not
intended for direct or indirect connection to the
public telephone network. When used with a
customer premise telephone system such as a
key system or PBX system, these units are
interfaced to the system via a fully protected loop
start trunk (FXO) port. Also, the host system
must be configured to disallow central office
trunk conferencing in order to prevent indirect
connection to the public network.
Precautionary Designations