Valcom Trunk Port VIP-820 사용자 설명서

947053

1

The VIP-820 networked trunk port allows an analog
PBX Station Port to be connected to a managed IP-
based Local Area Network ( LAN) or Wide Area
Network (WAN).

• 

PBX Station port (FXS) with open loop
disconnect signal provided

• 

RJ-45 for network connection

• 

RJ-11 telephone connection

• 

Front panel activity LED

• 

Network activity LEDs on RJ-45

• 4 

RENS

• 

2.5mm jack for DC power (115VAC TO 24VDC
adapter provided)

•  1.88" H x 5.50" W x 4.15" D
     (4.78cm H x 13.97cm W x 10.54cm D)

•  Weight:   0.55 lbs.  (0.25 kg)

Input Impedance:

600 Ohms

Input Level:

-10dBm

Output Impedance:

600 Ohms

Output Level:

- 10dBm nominal

Voltage:  

  24VDC

Current:  

  325mA

         

Temperature:

                          0 to +40 Degrees C

Humidity:    

               0 to 85% non-precipitating

NOTE:  The telephone system referred to in this
manual is the customer premise equipment such as
an electronic key system, a PBX or a dedicated single
line telephone sets.  The VIP-820 is not intended for
direct or indirect connection to the public telephone
network.  When used with a customer premise
telephone system such as a key system or PBX
system, these units are interfaced to the system via a

fully protected Extention /Station Port (FXS) port,
which is fully  protected interface device.  Also, the
host system must be configured to disallow central
office trunk conferencing in order to prevent indirect
connection to the public network.

The VIP-820 was designed for wall or table mounting.
Secure unit to wall studs or a suitable brace away
from heat sources or strong magnetic fields (motors,
fans, power supplies, etc.) with the control and
terminal strip accessible.  One wood screw is included
for mounting.

NOTE:  This equipment must be installed near an
AC power outlet due to the power cord being used
as a disconnect device.
•

The VIP-820 is provided with a VP-324 for North
American use.