Valcom IP Horn One-Way VIP-130L-M-IC 사용자 설명서

 

 1 

947728 

 

 

 

 
 

Mounting (VIP-LLE) 

The VIP-LLE Network Extender is designed for 
wall or shelf mounting and must be within 300 
feet of the network switch. 
 
Shelf: Provided with the VIP-LLE Network 
Extender are four rubber pads.  Peel the pads 
from the carrier backing and place at the four 
corners of the bottom of the unit. 
 
Wall: Using the brackets and wood screws 
provided, secure the VIP-LLE Network Extender 
to the wall. 
 

The horn should be mounted 15 to 20 feet 
above the floor to allow for best sound 
distribution.  The unit can be mounted to a wall, 
a beam or an electrical box. 

 

NOTE: For ease of installation, the base can be 
attached to the speaker before or after the base 
is mounted. 

  Loosen position adjustment knob 
 
  Insert the ball of the base into the socket 

of the speaker 

 

  Tighten the position adjustment knob 

 

  Mount the base to a wall using the two 

holes provided.  Knockout holes are 
provided for punch out should additional 
holes be desired. 

 

  A “C” clamp is provided with the horn to 

allow mounting to a beam.  Place the 
bolt through the hole in the bottom of the 
base to secure the “C” clamp to the 
beam.  It is suggested that the horn be 
mounted to the underside of the “I” 
beam to provide maximum positioning 
adjustments. 

 

  The base has pre-drilled holes for a 

double-gang square electrical box, but 
by drilling out additional knockout holes, 
the base can be mounted to a single-
gang or octagon box 

 
The horn may be rotated or moved up and down 
to obtain the desired position by loosening the 
position adjustment knob at the bottom of the 
unit approximately one turn.  Make required 
adjustments and re-tighten knob.