Trendnet TEW812DRU 사용자 설명서

TRENDnet User’s Guide

TEW-812DRU

Connect additional wired devices to your network

You can connect additional computers or other network enabled devices to your

network by using Ethernet cables to connect them to one of the available LAN ports

labeled 1,2,3,4 on your router. Check the status of the LED indicators (1, 2, 3, or 4) on

the front panel of your router to ensure the physical cable connection from your

computer or device.

Note: If you encounter issues connecting to your network, there may be a problem

with your computer or device network settings. Please ensure that your computer or

device network settings (also called TCP/IP settings) are configured to obtain IP

address settings automatically (also called dynamic IP address or DHCP) and to

Obtain DNS Server address settings automatically.

Wireless Networking and Security

How to choose the type of security for your wireless network

Setting up wireless security is very important. Leaving your wireless network open and

unsecure could expose your entire network and personal files to outsiders. TRENDnet

recommends reading through this entire section and setting up wireless security on your

new router.

There are a few different wireless security types supported in wireless networking each

having its own characteristics which may be more suitable for your wireless network

taking into consideration compatibility, performance, as well as the security strength

along with using older wireless networking hardware (also called legacy hardware).

It is strongly recommended to enable wireless security to prevent unwanted users from

accessing your network and network resources (personal documents, media, etc.).

In general, it is recommended that you choose the security type with the highest

strength and performance supported by the wireless computers and devices in your

network. Please review the security types to determine which one you should use for

your network.

Wireless Encryption Types

• WEP: Legacy encryption method supported by older 802.11b/g hardware. This is

the oldest and least secure type of wireless encryption. It is generally not

recommended to use this encryption standard, however if you have old 802.11 b or

802.11g wireless adapters or computers with old embedded wireless cards(wireless

clients), you may have to set your router to WEP to allow the old adapters to

connect to the router.

Note: This encryption standard will limit connection speeds to 54Mbps.

• WPA: This encryption is significantly more robust than the WEP technology. Much

of the older 802.11g hardware was been upgraded (with firmware/driver upgrades)

to support this encryption standard. Total wireless speeds under this encryption

type however are limited to 54Mbps.

• WPA-Auto: This setting provides the router with the ability to detect wireless

devices using either WPA or WPA2 encryption. Your wireless network will

automatically change the encryption setting based on the first wireless device

connected. For example, if the first wireless client that connects to your wireless

network uses WPA encryption your wireless network will use WPA encryption. Only

when all wireless clients disconnect to the network and a wireless client with WPA2

encryption connects your wireless network will then change to WPA2 encryption.

Gigabit

LAN Ports