Trendnet TW-H6W1IR 사용자 설명서
TW-H6W1IR ISDN Remote Router
PROM System Configuration
131
??
Boot Server IP Address – this specifies the IP address of the
server to be used to download the image file.
server to be used to download the image file.
??
Boot File Name – this specifies a complete path and filename on
the TFTP server. If you choose to use a configuration file, this
setting must show the path and filename to the configuration file. If
you are not using a configuration file, this must show the path and
filename to the software update image file.
the TFTP server. If you choose to use a configuration file, this
setting must show the path and filename to the configuration file. If
you are not using a configuration file, this must show the path and
filename to the software update image file.
??
Last Boot Server IP Address – this shows the last boot server
used to download an image file. This is for reference only.
used to download an image file. This is for reference only.
??
Last IP Address – this shows the last IP address used for the
LAN interface. Again, this is for reference only. The LAN port
must have an IP address in order to access the TFTP server via the
LAN network.
LAN interface. Again, this is for reference only. The LAN port
must have an IP address in order to access the TFTP server via the
LAN network.
??
Update Software from Configuration File – Either YES or NO.
If YES, the software update procedure will try to access a
configuration file located at the path defined in the above Boot File
Name. Please ensure that the path and file name of the software
image file is listed in the configuration file. If set to NO, the update
procedure will try to find an image file at the Boot File Name path.
Please see Appendix F – Configuration File for more information
about configuration files.
If YES, the software update procedure will try to access a
configuration file located at the path defined in the above Boot File
Name. Please ensure that the path and file name of the software
image file is listed in the configuration file. If set to NO, the update
procedure will try to find an image file at the Boot File Name path.
Please see Appendix F – Configuration File for more information
about configuration files.
After the parameters are set in the Software Update screen, SAVE the
changes, EXIT, and perform a System Reset or Execute Bootload to
begin the software download process.
changes, EXIT, and perform a System Reset or Execute Bootload to
begin the software download process.
After the new runtime software has been downloaded, the router will
automatically start up using the new software with the Software
Update Control setting DISABLED to avoid a downloading loop.
automatically start up using the new software with the Software
Update Control setting DISABLED to avoid a downloading loop.