Trendnet TW-H6W1IR 사용자 설명서
TW-H6W1IR ISDN Remote Router
20
Installation
? ?
If uplinking more than two hubs together, observe the 5-4-3 rule:
no signal, in order to go from one end node to another, must ever
pass through more than five twisted-pair cables, four repeaters
(that is, hubs), and three uplink cables. This is the maximum signal
path in twisted-pair Ethernet. Also be sure never to allow a signal
loop to form.
no signal, in order to go from one end node to another, must ever
pass through more than five twisted-pair cables, four repeaters
(that is, hubs), and three uplink cables. This is the maximum signal
path in twisted-pair Ethernet. Also be sure never to allow a signal
loop to form.
Note that you can connect an end node through the Uplink jack,
but to do so you must use a cross-wired cable or cable
converter.
but to do so you must use a cross-wired cable or cable
converter.
Step 6 - Powering Up Devices for Initial Configuration
Plug in the included 18V DC, 750 mA power adapter into the power
jack on the router’s rear panel.
jack on the router’s rear panel.