Troy-Bilt CSV206 사용자 설명서

12

•

Press down on the belt guard spring by the idler 
pulley, and release the spring from the slot on the 
idler bracket. 

•

Place the belt on the idler pulley and place belt 
guard spring back into the slot on the idler bracket. 
See Figure 17.

•

Place the mounting adapter against the engine and 
make sure the hole in the mounting adapter is 
facing up.

•

Place the inner housing against the mounting 
adapter and the frame. Secure with five hex bolts 
and two hex nuts previously removed. Refer to 
Figure 16.

•

Slide the impeller assembly onto the crankshaft 
and place a screwdriver under the belt. Turn the 
impeller assembly counterclockwise to place the 
belt into the slot on the impeller. Make sure the belt 
is routed inside all belt guards.

•

Secure impeller assembly to crankshaft using hex 
bolt, lock washer, and flat washer previously 
removed. Torque bolt between 550-700 in. lb.

•

Place the housing blades against the inner 
housing. Refer to Figure 15.

•

Place the outer housing against the inner housing. 
See Figure 18. Insert two screwdrivers into the 
holes to hold the blades in place while attaching the 
outer housing. 

•

Secure with the 14 self-tapping screws, previously 
removed. Insert all screws first before tightening.

•

Reassemble the flail screen, discharge chute, 
nozzle and the bag. (For reassembly, follow 
instructions on previous page in reverse order.)

A few general recommendations are given below. 
However, refer to the accompanying engine manual for 
further details. 

•

Check engine oil level before each use as 
instructed in the engine manual. Read and follow 
instructions carefully.

•

Clean air cleaner every 25 hours under normal 
conditions or once a season. Clean every few hours 
under extremely dusty conditions. To service the air 
cleaner, refer to the engine manual.

•

The spark plug should be cleaned and the gap 
reset once a season. Check engine manual for 
correct plug type and gap specifications.

•

Clean the equipment thoroughly.

•

Wipe equipment with an oiled rag to prevent rust.

•

Refer to engine manual for correct engine storage 
instructions

•

Store unit in a clean, dry area. Do not store next to 
corrosive materials such as fertilizer.

Never store the machine or fuel 

container indoors where there is an open 
flame, spark, or pilot light such as on a water 
heater, furnace, clothes dryer, or other gas 
appliance.