Troy-Bilt RZT 사용자 설명서

P

P

P

P

P

P

P

P

P

NOTE: This Operator’s Manual covers several models. Tractor 

features may vary by model. Not all features in this manual are 

applicable to all tractor models and the tractor depicted may 

differ from yours.

Before performing any maintenance or 

repairs, disengage the PTO, move the drive control 

levers fully outward in the neutral position, engage 

the parking brake, stop the engine and remove the 

key to prevent unintended starting.

Refer to the Engine Manual for all engine maintenance intervals, 

procedures, specifications and instructions.

• 

Using a pressure lubricating gun, lubricate the front castor 

wheel axles with Cub Cadet 251H EP grease after every 10 

hours of service.

• 

Periodically lubricate all other pivot points with a quality 

lubricating oil.

Once a month remove the belt covers to remove any 

accumulation of grass clippings from around the spindle pulleys 

and V-belt. Clean more often when mowing tall, dry grass.

When using the deck wash system, never 

engage the deck from any position other than the 

operator’s seat of the tractor. Do not use an assistant or 

engage deck in the presence of any bystanders. 

1. 

Attach the nozzle adapter to a standard garden hose 

connected to a water supply. 

2. 

Move the tractor to an area within reach of the hose where the 

dispersal of wet grass clippings is acceptable to you. Disengage 

the PTO, engage the parking brake and stop the engine.

3. 

Pull back the lock collar of the nozzle adapter and push the 

adapter onto one of the deck wash nozzles at either end of 

the mower deck. Release the lock collar to lock the adapter 

on the nozzle. See Figure 6-1.

4. 

Turn on the water supply. 

5. 

From the tractor operator’s seat, start the engine and 

engage the PTO. Allow to run as needed. Disengage the 

PTO and stop the engine.

6. 

Turn off the water supply. 

7. 

Pull back the lock collar of the nozzle adapter to disconnect 

the adapter from the nozzle. 

8. 

Repeat the previous steps to clean the deck using the 

nozzle at the other end of the deck.