Troy-Bilt TB-38 사용자 설명서

• 

3/8-inch wrench (or adjustable wrench)

• 

7⁄16-inch wrench (or adjustable wrench)

• 

1/2-inch socket wrench

: 

Battery posts, terminals, and related accessories 

contain lead and lead compounds, chemicals known 

to the State of California to cause cancer and 

reproductive harm. Wash hands after handling.

When attaching battery cables, always 

connect the POSITIVE (Red) wire to its terminal first, 

followed by the NEGATIVE (Black) wire.

For shipping reasons, both battery cables on your equipment 

may have been left disconnected from the terminals at the 

factory. To connect the battery cables, proceed as follows:
NOTE: The positive battery terminal is marked Pos. (+). The 

negative battery terminal is marked Neg. (–).
1. 

Remove the plastic cover, if present, from the positive 

battery terminal and attach the red cable to the positive 

battery terminal (+) with the bolt and hex nut. See Figure 3-1.

2. 

Remove the plastic cover, if present, from the negative 

battery terminal and attach the black cable to the negative 

battery terminal (–) with the bolt and hex nut. See Figure 3-1.

3. 

Position the red rubber boot over the positive battery 

terminal to help protect it from corrosion.

NOTE: If the battery is put into service after the date shown 

on top/side of battery, charge the battery as instructed in the 

Maintenance section your Operator’s Manual prior to operating 

the tractor.

Never operate the mower deck 

without the chute deflector installed and in the 

down position. 

1. 

Check the mower deck for a shipping brace that may be 

holding the chute deflector upward for shipment. If the 

brace is present, it must be removed before operating the 

tractor. Holding the chute deflector fully upward, remove 

the shipping brace. Lower the chute deflector and discard 

the shipping brace. See Figure 3-2.