Troy-Bilt 2690XP 사용자 설명서

Refer to the Engine Operator’s Manual packed with your snow 

thrower for instructions on starting and stopping the engine.

1. 

With the throttle control in the Fast (rabbit) position, move 

shift lever into one of the six forward (F) positions or two 

reverse (R) positions. Select a speed appropriate for the 

snow conditions and a pace you’re comfortable with. 

2. 

Squeeze the drive control against the handle the snow 

thrower will move. Release it and drive motion will stop.

To engage the augers and start throwing snow, squeeze the 

auger control against the left handle. Release to stop the augers.

With the drive control engaged, squeeze the right steering 

trigger control to turn right. Squeeze the left steering trigger 

control to turn left. 

It is recommended that you wear 

gloves when using the heated grip. If the heated 

grip becomes too hot, turn it off. 

To activate the heated grips, move the switch found on the rear 

of the dash panel into the ON position. See Figure 5-1.

The augers are secured to the spiral shaft with shear pins and 

bow-tie cotter pins. If the auger should strike a foreign object or 

ice jam, the snow thrower is designed so that the pins may shear. 

If the augers will not turn, check to see if the pins have sheared. 

See Figure 5-2.

NEVER replace the auger shear pins 

with anything other than OEM Part No. 738-04124A 

replacement shear pins. Any damage to the auger 

gearbox or other components as a result of failing to 

do so will NOT be covered by your snow thrower’s 

warranty.

Always turn off the snow thrower’s 

engine and remove the key prior to replacing shear 

pins.