DMP Electronics XR500 사용자 설명서

46

area informaTion
18.10.2  

INT  BDRM  PERIM

When Home/Sleep/Away is selected as the system type, program the Interior,

Bedroom, and Perimeter areas as needed.

* UNUSED *

The area name can be up to 32 alphanumeric characters.  To add an area name to the 

system, press any Select key and then enter up to 32 characters for the new area name.  

Press COMMAND to continue. For instructions on entering alphanumeric characters see

section 1.7 Entering Alpha Characters. Inactive areas are marked * UNUSED *. Only

systems programmed for Area arming have the option available to change the area name.
To mark an active area unused, press any top row Select key to delete the old name, 

then press the COMMAND key. The programmer automatically programs the name

as *UNUSED*. If you have already cleared Area Information during Initialization, all

areas are marked * UNUSED *. See Initialization section.
Home/Sleep/Away with Guest systems display the area name, but the names cannot

be changed.  The following are the display names that appear on the keypad:

1

Perimeter

4

Guest1 Perimeter

7

Guest2 Perimeter

2

Interior

5

Guest1 Interior

8

Guest2 Interior

3

Bedrooms

6

Guest1 Bedrooms

9

Guest2 Bedrooms

ACCOUNT NO: 12345

Enter the account number to be sent to the receiver for this area.  Choose an account 

number compatible with the Communication Type selected in Communications.  The 

default Account Number is the one previously entered in Communications. This 

account number is used when sending area messages and events to the central station. 

See the Area Account Number Messages in the Appendix.  

AUTO ARM  NO  YES

Select YES to allow this area to arm automatically according to permanent, temporary, 

or extended schedules.  If no schedules are programmed, the area auto arms every hour.
If closing check is selected as YES, the automatic arming function does not take 

place until the expiration of a ten minute Closing Check delay.  See Closing Check.  

If the area has been disarmed outside of any permanent or temporary schedule, the 

closing check sequence occurs one hour after the area is disarmed.
At arming, bad zones are handled according to the option selected in section Bad 

Zones. If a closing report is sent, the user number is indicated as SCH on the SCS-1R

Receiver. NO disables automatic arming for this area.

BAD ZONES:    BYP

At the time of automatic arming, some zones in the area may not be in a normal 

condition.  This option allows you to program the panel response to these bad zones.  

This option does not display if AUTO ARM is NO.

BYP  FORC    REF

BYP - All bad zones are bypassed.  A report of the bypass is sent to the receiver if 

Bypass Reports is YES.  The report indicates SCH as the user number.
FORC - All bad zones are force armed. Zones force armed in a bad condition are

capable of restoring and reporting an alarm if tripped.  A forced zone report  is 

transmitted if Bypass Reports is YES.  The report indicates SCH as the user number.
REF - The automatic arming is refused and no arming takes place.  A No Closing 

report is sent to the receiver regardless of the Closing Check selection.

AUTO DIS  NO  YES

NO disables automatic disarming by schedule for this area. When YES is selected,

the area automatically disarms according to permanent or temporary schedules.  If 

an opening report is sent to the receiver, the user number is indicated as SCH.