Clarity INT9 사용자 설명서

Clarity - INT9 A/D converter 

 Installation 

and tinned endings – red (+), white (-) and 

shielding (analogue ground)]. 

•  Starting (marker) cables 

Labelled  “IN1” to “IN4” (correlating to channel 

number) and tipped with CINCH connector 

(female). 
The following cables can be connected to this 

CINCH connector: 
•  A cable terminated with free leads [red (+), 

shielding (digital ground)] for direct 

connection to the chromatograph. 

•  A cable terminated with a button for cases 

where a starting contact is not available and 

it is necessary to perform a manual start. 

Both types of cable are supplied for each 

starting cable. 

•  Digital output cables  

Relay contacts labelled "OUT1R" to "OUT4R" 

(according to the number of channels), 

terminated with free leads. These are used for 

synchronizing autosamplers without an AS 

Control module in the Active Sequence or for 

controlling other devices. 
At the converter end the cable is always 

terminated with a D-SUB 37-pin connector 

(female). 

Connect the cables according to one of the 

following diagrams in Fig. 2. Use the 

symmetrical connection  only  when  you  are 

sure that the chromatograph/detector is 

equipped with a symmetrical output – it is 

necessary to read through the instructions for 

the corresponding chromatograph. 
All current DataApex A/D Converters INT7, 

INT9, U-PAD, U-PAD2 and Net-PAD use the same 

standard INT7 Connector.