JVC HR-J670 사용자 설명서
Filename [HRJ670EU1.fm]
Masterpage:Right
EN
13
SAT CONTROL SET
Satellite Receiver
Control Setting
Control Setting
The following procedure is required if you receive
satellite channels through a satellite receiver.
Approximately 20 seconds before the S
satellite channels through a satellite receiver.
Approximately 20 seconds before the S
HOW
V
IEW
timer
programming (
墌
pg. 24) or Express timer programming
(
墌
pg. 26) starts, the recorder sets its input mode to “L-2”
and automatically switches the satellite receiver’s
channels using an optional Satellite Controller.
channels using an optional Satellite Controller.
Installing Satellite Controller
A
Situate the Satellite Controller.
Place the Satellite Controller so that the path between its
transmitter and the satellite receiver’s remote sensor is
unobstructed.
transmitter and the satellite receiver’s remote sensor is
unobstructed.
B
Attach the Satellite Controller.
Fix securely using the adhesive strip attached on the back
of the Satellite Controller.
of the Satellite Controller.
C
Make connections.
Be sure to connect the recorder’s AV2 (L-2) IN/DECODER
connector to the satellite receiver’s 21-pin SCART
connector.
connector to the satellite receiver’s 21-pin SCART
connector.
NOTE:
When connecting your satellite receiver, refer to its instruction
manual.
manual.
D
Connect the Satellite Controller to recorder.
Connect the Satellite Controller to the SAT CONTROL
connector on the rear panel.
connector on the rear panel.
Satellite receiver
Satellite Controller
(not provided)
(suggested locations)
(not provided)
(suggested locations)
Transmitter
21-pin SCART
cable
(not provided)
SAT CONTROL
AV2 (L-2) IN/DECODER
Your recorder
Satellite Controller
(not provided)
(not provided)
Back of recorder
Satellite receiver
HRJ670EU1.fm Page 13 Thursday, December 9, 1999 3:48 PM