Maxtor NVR-2028 사용자 설명서

 

73

1. When in the single –device mode, click 

  to enter the NVR SETUP page. (See the sample screen in A 

above) 

2. Select a desired recording rate and Quality from the corresponding drop-down list 

3. On the left side of the page are itemized Lancams 1(

) to 8(

) (see the 

sample screen in C above), each of which is connected to the corresponding camera. So, if you 

click any of them, the information of the corresponding camera will appear in the entries of all the 

items on the screen. 

4. Adjust the LANCAM setup, including all the items on the screen given below: 

Title 

Connect LanCam 

Motion (see the sample screen in D above) 

The information in the entries for the above items can be sent to the NVR. 

5. Click the OK tag to proceed.     

Set the Alarm record settings 

1. When in the single –device mode, click 

  to enter the NVR SETUP page (see the sample screen in A 

above). 

2. Set the ALARM SETTING to ON to enable the drop-down list in the ALARM SETTING area. 

3. Select a desired recording rate, recording duration and pre-alarm from the corresponding 

drop-down list. 

4. Click the OK tag to proceed. 

Set the Record Schedule 

1. When in the single –device mode, click 

  to enter the NVR SETUP page (see the sample screen in 

B above) 

2. Click the check mark in the

 

Enable Record Schedule to ON to enable the Record Schedule setting 

area. 

3. Choose a day of the week from the Time-Period list to set the schedule for recording for each day.   

4. Click the Modify button to enter the Time Setting page (see the sample screen in B-1 above) 

5. Go to both the Start Time & End Time boxes, select a specific Hour: Minute and click the Add button to 

add to the Schedule Record List. 

6. When all required settings are completed, click OK to proceed.