Philips Original radio ORD7100R ORD7100R/37 사용자 설명서

13

EN

11 Troubleshooting

Warning

 

•

Never remove the casing of this product.

To keep the warranty valid, never try to repair the product yourself. 

If you encounter problems when using this product, check the following points before requesting 

service. If the problem remains unsolved, go to the Philips Web page (www.philips.com/support). When 

you contact Philips, make sure that the product is nearby and the model number and serial number are 

available.

Problem

Solution

No power

Make sure that the AC power cord is connected properly.
Make sure that there is power at the AC power outlet.
If a connected iPod/iPhone stays inactive for 15 minutes when it 

is selected as the source, the system switches to standby mode 

automatically.

No sound or poor sound

Adjust the volume.
Press MUTE to release the speakers from mute status.

No response from the 

product

Reconnect the AC power cord, and then turn on the product again.
If a connected iPod/iPhone stays inactive for 15 minutes when it 

is selected as the source, the system switches to standby mode 

automatically.

Remote control does not 

work

Before you press any function button, select the correct source with the 

remote control instead of the system.
Reduce the distance between the remote control and the system.
Insert the battery with its polarity (+/– signs) aligned as indicated.
Replace the battery.
Aim the remote control at the iR sensor on the front panel of the 

system.

Poor radio reception

Increase the distance between the product and other electrical 

appliances.
Fully extend the antenna.
Connect an outdoor FM antenna instead.

Clock is erased

Power has been interrupted or the AC power cord has been 

disconnected.
Reset the clock.