Netgear FS205 FS205-100PES 전단

              Installation 

Guide

Estimated installation time: 5-10 minutes

This package includes:

Ethernet Switch FS205/FS208

AC power adapter

Installation Guide (this document)

Place the switch on a flat horizontal surface such as a table, 
desk, or shelf. You can use wall-mounting screws (not provided) 
to hang the switch in an open space on a wall.

Make sure that the selected location is:

Not in direct sunlight or near a heater or heating vent.

Not cluttered or crowded. There must be at least 2 inches 

(5 cm) of air space on all sides of the switch.

Well ventilated (especially if it is in a closet).

You need a Category 3 (10 Mbps) or Category 5 (100 Mbps) 
Ethernet cable with RJ-45 connectors for each device you 
connect to the switch. Each Ethernet cable must be less than 
328 feet (100 meters).

Place the switch on a flat surface or hook it onto the screws.

For each device, insert one end of an Ethernet cable into a 

port on the switch and the other end into the network port 

on the device.

Connect the power adapter cord into the back of the switch 

and then plug the adapter into a power source (such as a 

wall socket or power strip).

Check the LEDs:

Verify that the Power LED is lit.

For each jack that is connected to a powered device, 

check that the Link LED is lit and it flashes when activity 

occurs.

If any LED does not operate as indicated, go to the 

Troubleshooting section.

 

Power

Modem

FS208 8-Port
Ethernet switch

Firewall

Power

FS205_FS208_IG small.fm  Page 1  Tuesday, August 7, 2012  9:57 AM