ZyXEL Wireless Access Point G1000 91-005-124003B 사용자 설명서
제품 코드
91-005-124003B
G-1000 User’s Guide
66
Chapter 6 Wireless LAN
Figure 23 Wireless LAN: 802.1x/WPA for WPA-PSK Protocol
The following table describes the labels not previously discussed
6.7.4 Authentication Required: WPA2
Select Authentication Required in the Wireless Port Control field and WPA2 in the Key
Management Protocol field to display the next screen.
Management Protocol field to display the next screen.
Table 19 Wireless LAN: 802.1x/WPA for WPA-PSK Protocol
LABEL
DESCRIPTION
Key Management
Protocol
Choose WPA-PSK in this field.
Pre-Shared Key
The encryption mechanisms used for WPA and WPA-PSK are the same. The only
difference between the two is that WPA-PSK uses a simple common password,
instead of user-specific credentials.
Type a pre-shared key from 8 to 63 case-sensitive ASCII characters (including
Type a pre-shared key from 8 to 63 case-sensitive ASCII characters (including
spaces and symbols).
WPA Group Key
Update Timer
The WPA Group Key Update Timer is the rate at which the AP (if using WPA-
PSK key management) or RADIUS server (if using WPA key management) sends
a new group key out to all clients. The re-keying process is the WPA equivalent of
automatically changing the WEP key for an AP and all stations in a WLAN on a
periodic basis. Setting of the WPA Group Key Update Timer is also supported in
WPA-PSK mode. The G-1000 default is 1800 seconds (30 minutes).
Apply
Click Apply to save your changes back to the G-1000.
Reset
Click Reset to begin configuring this screen afresh.