Omnitron iConverter T1/E1 MUX/M 2423-1-32 사용자 설명서

The following application shows an example of the iConverter 

T1/E1  MUX/M  used  in  a  hybrid  TDM/Ethernet  transport 

network.
A  wireless  service  provider  has  enhanced  their  network  to 

support 3G/4G services.  The new equipment uses Ethernet for 

backhaul at the Cell Site, while their existing legacy 2G/2.5G 

equipment uses TDM (T1) for backhaul.
Using the iConverter T1/E1 MUX/M at the Cell Site, the service 

provider is able to multiplex up to 16 T1/E1 circuits and one 

10/100/1000 Ethernet service on a common fiber link.  The 

fiber  carries  the  multiplexed  traffic  to  a  second  iConverter  

T1/E1 MUX/M that is installed at the Base Station Controller 

(BSC) and Radio Network Controller (RNC).  The T1/E1 MUX/M 

converts the legacy TDM traffic back to T1/E1 interfaces, where 

it is connected to the TDM network.  The MUX also converts 

the Ethernet traffic back to a 10/100/1000 interface, where it 

is connected to the provider’s IP network.

Page 2

 T1/E1 MUX/M 

ANSI: T1.403, T1.102, 

AT&T: T62411, ITU: G.703, G.704, G.706, G.736,              

G.775, G.823,  G.824, G.8261

ETSI: ETS 300 166

10BASE-T, 100BASE-TX, 1000BASE-T

100BASE-FX, 1000BASE-X

10,240 byte frames

Copper Connectors Ethernet:   RJ-45

T1/E1:       RJ-48

SFP Model: LC

Dual Fiber Model: SC, ST

Single-Fiber Model: SC

W: 17.15” x D: 9.0” x H: 1.75”

1 Power Supply:    7.5 lb

2 Power Supplies: 9.0 lb

UL, CE, FCC Class A, NEBS 3 Compliant

5 to 95% (non-condensing)

-100m to 4000m

Input Power 

Requirements:
Connector:

100 to 240VAC 50/60Hz  

 0.5A @ 120VAC
 IEC320

Input Power 

Requirements:
Connector:

 18 to 36VDC 

 1.4A

 @ 24VDC

 3-pin terminal

Input Power

Requirements:
Connector:

 36 to 60VDC 

 0.7A

 @ 48VDC

 3-pin terminal

Standard:

Wide:

Storage:

0 to 50° C

-40 to 60° C

-40 to 80° C

16 Ports with Redundant  

AC or DC Power Supplies:  83,000