Tandberg Data SATA DLT-V4 Internal Grey 7301709300 사용자 설명서

DLT-V4 Product Manual Guide

4

Chapter 2

2

Installing the Tape Drive 

This chapter explains how to configure and install the tape drive. 

Configuration and installation are not difficult and require only that you 

follow the instructions presented in this chapter.

Preparing to Install the Tape Drive

2

This section helps you prepare to install the DLT-V4 tape drive (tabletop 

or internal).

2

Installing the DLT-V4 SCSI tabletop tape drive requires no special tools. 

For the SCSI interface, you will need a ballpoint pen to change the SCSI 

ID switch on the rear panel of the tape drive. 
If you are installing a DLT-V4 SATA internal tape drive, see 

 on page 25 for instructions. Installing the DLT-

V4 internal tape drive requires only the usual tools needed to install an 

internal tape drive in the computer you have chosen to house the tape 

drive (for example, a screwdriver and some ESD protection).

2

The DLT-V4 SCSI interface tape drive (tabletop and internal) incorporates 

a wide Ultra160 low-voltage differential (LVD) small computer system