HP 721953-171 사용자 설명서

To dynamically choose a boot device for the current startup sequence, follow these steps:

Open the Select Boot Device menu by turning on or restarting the computer, and then pressing 

esc

 while

the “Press the ESC key for Startup Menu” message is displayed at the bottom of the screen.

Press 

f9

.

Use a pointing device or the arrow keys to select a boot device, and then press 

enter

.

To start Computer Setup and set the computer to display the MultiBoot startup location menu each time the
computer is started or restarted, follow these steps:

Turn on or restart the computer, and then press 

esc

 while the “Press the ESC key for Startup Menu”

message is displayed at the bottom of the screen.

Press 

f10

 to enter Computer Setup.

Use a pointing device or the arrow keys to select System Configuration > Boot Options, and then press

enter

.

In the MultiBoot Express Popup Delay (Sec) field, enter the length of time in seconds that you want the
computer to display the startup location menu before it defaults to the current MultiBoot setting.
(When 0 is selected, the Express Boot startup location menu is not displayed.)

To save your changes and exit Computer Setup, click the Save icon in the lower-left corner of the
screen, and then follow the on-screen instructions.

– or –

Use the arrow keys to select File > Save Changes and Exit, and then press 

enter

.

Your changes go into effect when the computer restarts.

When the Express Boot menu is displayed during startup, you have the following choices:

●

To specify a boot device from the Express Boot menu, select your preference within the allotted time,
and then press 

enter

.

●

To prevent the computer from defaulting to the current MultiBoot setting, press any key before the
allotted time expires. The computer will not start until you select a boot device and press 

enter

.

●

To allow the computer to start according to the current MultiBoot settings, wait for the allotted time to
expire

Using MultiBoot

93