Hunter Sea Air 23568 사용자 설명서

Hunter Fan Company 

42701-01 • 01/25/06 

42701-01 • 01/25/06 

Hunter Fan Company

 

 WARNING:  Fan may fall if not assembled as directed in these 

installation instructions.

3-1.  Unbundle the wires from the fan.
For Standard or Angle mounting:
3-2.  To assemble fan to hang down from a flat or angled ceiling, insert 

the downrod through the canopy. Feed the wires from the fan 
through the downrod. 

3-3.  Loosen the square head set screw on the adapter to install the 

pipe and ball assembly. Note: When the pipe and ball assembly 
is fully installed, 2-3 threads on the pipe will still be visible; this is 
normal. Securely retighten the set screw with a wrench or pliers. 

3-4.  Align and engage the two tabs from the bottom of the canopy 

and the two grooves in the hanger ball. Skip to 3-9.

     

 CAUTION: e adapter has a special coating on the threads. Do 

not remove this coating; the coating prevents the downrod from 
unscrewing. Once assembled, do not remove the downrod.

For Low Profile mounting:
Note: For low profile mounting, the downrod is not used. 
3-5.  Remove the set screw from the adapter.
3-6.  Using a sharp pointed tool, pierce three holes in the rubber gasket 

where indicated by the holes in the housing. 

3-7.  Align the holes in the bottom of the canopy with the holes in the 

motor housing and gasket.

3-8.  Install three low profile screws to secure the canopy to the motor 

housing.

Hanging the fan:
3-9.  Raise the fan and place the hook on the ceiling plate through the 

round hole in the rim.

Downrod 

Canopy

Round 

Hole

Set Screw

Adapter

Low Profile Screw

Canopy

Alignment 

Hole

Motor 

Housing

Low Profile Screw