Tandberg Data StorageLoader 2U LTO, 1 x 10 LTO-3 052102 사용자 설명서

1016988



The tape drive automatically performs the cleaning in less than a minute 

and ejects the cartridge when finished. 



During the cleaning, the front panel displays an Clean Drive Active 

message.



After a successful cleaning, the library displays this confirmation 

message: Cleaning Good. Once the message appears, press OK to 

continue.



If the cleaning was not successful, a message explaining the failure 

appears on the screen. You may be prompted to insert a new cleaning 

cartridge. See 

.



If necessary, use the Export command to remove the cleaning cartridge 

from the library, as described on 

. Before closing the I/E port 

door, insert the data cartridge you removed previously (if applicable). 

Then, firmly push the door closed. 

7.

7.

7.

7.

Press Back (as needed) to return to the Home screen. 

If the library or tape drive has encountered an error and is not operating as 

expected after you have tried the recommended corrective actions, you may 

need to perform a reset. 



Front panel reset—Instructions begin on 

.



Back panel reset—You can reset both the library and the tape drive(s) by 

powering the library off and back on (press the 

 to power the library off, 

and then press the 

 to power the library back on).

You may also be able to perform resets from your application software. 

Refer to your software documentation for instructions.