Tandberg Data StorageLoader 2U LTO, 1 x 20 LTO-3 052103 사용자 설명서
제품 코드
052103
A
PRIL
2007
S
TORAGE
L
OADER
2U LTO
169
R
EPLACING
A
T
APE
D
RIVE
(
SAME
CONFIGURATION
)
b.
b.
b.
b.
Reconfigure your library—You must reconfigure your library for your
backup application to recognize the new tape drive. See
for
instructions.
R
EPLACING
A
T
APE
D
RIVE
(
SAME
CONFIGURATION
)
To replace a tape drive with a different tape drive of the same configuration
(half height to half height, or full height to full height), follow these steps.
1.
1.
1.
1.
Preparing for replacement—
a.
a.
a.
a.
Power off the host.
b.
b.
b.
b.
Power off the library (press the 0 on the back of the unit).
c.
c.
c.
c.
Disconnect the power cord, the SCSI or Fibre Channel cable(s), and the
terminator (if present).
d.
d.
d.
d.
Remove the tape drive cover plate. Set the plate and the screws aside.
2.
2.
2.
2.
Removing the tape drive—
a.
a.
a.
a.
Pull the tape drive a short distance out of the library, and then disconnect
the serial cables (
S
) from the tape drive(s) that you are replacing.
b.
b.
b.
b.
Disconnect the power cables (
P
) from all of the tape drives.
! ! ! !
Important
The library requires both the SCSI cover plates and the tape
drive cover plates for ESD protection. Do not leave any
openings uncovered.
Do not connect the SCSI cables until after you reconfigure the
Do not connect the SCSI cables until after you reconfigure the
library.
Figure 7-8 Tape drive cover plate (Fibre Channel library)
Power OFF
Disconnect
power cord
power cord
Tape drive
cover plate
cover plate
Screws
(press the 0)
Back of library
Screws