Tandberg Data StorageLoader 2U LTO, 1 x 20 LTO-3 052103 사용자 설명서
제품 코드
052103
12
P
RODUCT
M
ANUAL
1016988
C
HAPTER
2—I
NSTALLING
THE
L
IBRARY
P
REPARING
FOR
I
NSTALLATION
Before installing the library:
Make sure that the SCSI host bus adapter card installed in the host
computer, any necessary device drivers, and your backup software are
compatible with the library. Make certain that an Ultra 160 SCSI host bus
adapter (HBA) and any necessary drivers installed in the host computer are
compatible with the tape drive(s).
For optimum performance, use an Ultra160 SCSI host bus adapter.
If your software has not yet been certified for the StorageLoader 2U LTO,
you can use one of the library’s emulation modes (see
).
You can install the software on the host computer before or after library
installation. However, if you install the software first, you may need to
reconfigure it for use with the library after library installation is
complete.
Locate an appropriate area for the library. Select a location that has
adequate clearance for ventilation, minimal dust and debris, and an
appropriate power source. The library is designed to operate either in a
desktop configuration, or in a standard 19-inch rack. To provide adequate air
flow, a ventilated rack is recommended.
The library must be operated in the horizontal position. Do not place the
library on its side, and do not place objects on top of the library.
Ensure that the work area is free from conditions that could cause
electrostatic discharge (ESD). Discharge static electricity from your body by
touching a known grounded surface, such as a computer’s metal chassis.
! ! ! !
Important
Both LTO-2 and LTO-3 SCSI tape drives are Ultra 160 SCSI
devices and require a minimum Ultra 160 non-RAID SCSI host
bus adapter card.
Warning
Before performing any installation or maintenance procedures, be sure that the
library power switch is in the off position and that the power cord is disconnected
from the library and the outlet.
Warnung
Vor der Ausführung von Installations- oder Wartungsarbeiten ist darauf zu achten,
daß der Library-Netzschalter auf “Aus” gestellt ist und daß das Anschlußkabel vom
Library und der Steckdose entfernt ist.
Advertencia
Antes de realizar cualquier procedimiento de instalación o de mantenimiento,
comprobar que el interruptor de alimentación de la biblioteca está apagado y que
el cable de alimentación no está enchufado ni a la biblioteca ni a la toma de
corriente.