Swann MicroCam III SW-P-MC3 사용자 설명서

The MicroCam III features an omni-directional antenna which is most effective when used 
in the UPRIGHT position.

1)

2)

3)

After connecting both the MicroCam III and the Receiver make sure the receiver is 
switched to channel 3. Press the SEL button on the receiver until the LED for CH3 is lit. If 
the channel LEDs flash and the receiver scans through all 4 channels, switch the 
Loop/Normal selector at the back of the receiver to Normal. Obtain the best picture by 
adjusting the position of the MicroCam III and Receiver unit to suit. Try slightly different 
locations of either unit for optimum results. 

4)

5)

Please note: Channels 1, 2 and 4 are not used with this camera. Accessory cameras to take 
advantage of the other channels are available for separate purchase. We suggest the Night Hawk 
Extra Camera (SW-P-WOCEX) which is a Wireless Weatherproof Outdoor Camera with Night 
Vision or the MicroCam IV (SW-P-MC4) Indoor Color Camera. Both of these camera models have 
DIP switches to allow them to use of any of the other available channels on your MicroCam III 
receiver.

IMPORTANT: In accordance with privacy regulations in some countries this camera does 
not have any audio transmission capability where this is prohibited by law. Please consult 
your privacy regulations, or contact the relevant government department for more 
information.

Poor Picture: Realign antennas until image quality improves, slightly adjust the position of the 
Camera or Receiver. Change the location of the Camera, or use a different height or angle to see if 
the image improves. In some cases interference may be caused by another device on a similar 
frequency to the channel you are using.

Lines only - no clear picture: Check to confirm there is no microwave oven or other 2.4GHz 
equipment operating close by ie;  Cordless Telephones, Wireless Baby Monitors, Wireless LAN 
equipment etc . Make sure the Receiver is on the correct channel (CH3).

Picture ghosting or interference: Some home appliances such as Wireless LANs, 2.4GHz 
portable telephones and Microwave ovens operate on or near the 2.4GHz frequency. If you receive 
interference from such an appliance, try moving the Camera or Receiver to location further away 
from the appliance or in the event of interference from a Wireless LAN device, try changing the 
Wireless LAN to a different channel to improve the signal quality.

No picture: check the receiver to confirm it is turned ON and make sure the A/V connection of the 
Receiver is not plugged into the Audio Out socket. Make sure the Receiver is on the correct 
channel. Check to ensure the camera is plugged in and has power. Check that the channel on the 
receiver is the set to Channel 3.

Red haze over picture: In some cases where the sun shines into the front of the camera a faint 
red glow can be seen. Move the camera to a shaded location, or fit a hood to stop sunlight entering 
the camera lens directly.

Foreground is dark while background is too bright: If the camera is looking from a dark area 
towards a light area in some cases the automatic exposure can find it difficult to balance the image 
correctly. Change the location of the camera so that the point of greatest interest has the largest 
area of the image.(if you want to see the bright area, move the camera so that almost all of the 
screen shows this area. If you want to see the darker area, move the camera so that most of the 
image shows this area.