Audix ADX40-HC 전단
Transducer Type
Condenser
Frequency Response 40 Hz - 20 kHz
Polar Pattern Cardioid
Hypercardioid (ADX40-HC)
Output Impedance 250 Ohms balanced
Sensitivity 5 mV / Pa @ 1k
Equivalent Noise Level 29 dB (A weighted)
Signal to Noise Ratio 65 dB
Power Requirements 9 - 52 Volts phantom
Maximum SPL ≥130 dB
Cable/Connector Shielded 30’ terminating to
a miniature 3 pin
Female XLR connector
Polarity Positive pressure on
diaphragm produces
positive voltage on pin
2 relative to pin 3
Housing/Finish Brass /
Black E-Coat
Weight 110 g / 4 ounces
Length 30 mm / 1.2 inches
SPECIFICATIONS:
ARCHITECTS AND ENGINEERS SPECIFICATIONS:
The microphone shall be of the condenser type with a modular threaded capsule. The microphone
shall be available in cardioid and hypercardioid polar patterns and shall have a 30’ cable terminat-
ing in a mini-XLR female connector. The microphone shall be provided with a remote cylindrical
phantom power adapter that will allow the microphone to operate between 9 volts and 52 volts
phantom power. The microphone shall have a sensitivity of 5 mV / Pa and a nominal impedance of
250 ohms at 1 kHz. The microphone shall have a maximum SPL level of ≥130 dB. The microphone
shall be machined out of brass with a length of 30 mm and a capsule diameter of 12 mm. The
microphone shall be the Audix ADX40.
shall be available in cardioid and hypercardioid polar patterns and shall have a 30’ cable terminat-
ing in a mini-XLR female connector. The microphone shall be provided with a remote cylindrical
phantom power adapter that will allow the microphone to operate between 9 volts and 52 volts
phantom power. The microphone shall have a sensitivity of 5 mV / Pa and a nominal impedance of
250 ohms at 1 kHz. The microphone shall have a maximum SPL level of ≥130 dB. The microphone
shall be machined out of brass with a length of 30 mm and a capsule diameter of 12 mm. The
microphone shall be the Audix ADX40.
OPERATION AND MAINTENANCE:
The ADX40 is a low impedance microphone and should be plugged into a “mic level” input on your
console, mixer, or recording device. The ADX40 requires phantom power and will NOT operate
without phantom power voltage (minimum of 9 - 48 Volts) which is available on most professional
mic preamps and mixing devices. If phantom power is not available on your equipment, you may
use the APS-911 which is an optional accessory that allows for battery operation. Avoid plugging or
unplugging the microphone from a PA system unless the channel is muted or the volume of the system
turned down. Failure to do so may result in a loud “popping” noise which could seriously damage the
speakers in the PA system.
console, mixer, or recording device. The ADX40 requires phantom power and will NOT operate
without phantom power voltage (minimum of 9 - 48 Volts) which is available on most professional
mic preamps and mixing devices. If phantom power is not available on your equipment, you may
use the APS-911 which is an optional accessory that allows for battery operation. Avoid plugging or
unplugging the microphone from a PA system unless the channel is muted or the volume of the system
turned down. Failure to do so may result in a loud “popping” noise which could seriously damage the
speakers in the PA system.
APS-910 phantom power adapter: Note that the mini-XLRf connector at the end of the ADX40
mic cable plugs into mini-XLRm side of the APS-910 power adapter. From there, plug a standard
XLR-XLR microphone cable to complete the connection from the APS-910 to the mixing board.
XLR-XLR microphone cable to complete the connection from the APS-910 to the mixing board.
Windscreen: The supplied windscreen is not necessary when using the ADX40 in the overhead
position.
USER TIPS:
*Futher miking techniques may be found on our website at www.audixusa.com
As an overhead mic: The ADX40 is designed for an area of 6-8 feet
wide. Two microphones can usually cover a 15 foot wide area when
placed strategically. Refer to mic placement drawing.
placed strategically. Refer to mic placement drawing.
As a stand mounted mic: The ADX40 can also be used on a standard
microphone stand for speech by using one of the optional mic stand
adapters (SMT-MICRO or MC-MICRO). When using the ADX40 for
speech, the foam windscreen is recommended to help control popping
or wind noise.
adapters (SMT-MICRO or MC-MICRO). When using the ADX40 for
speech, the foam windscreen is recommended to help control popping
or wind noise.
FREQUENCY / POLARS:
DIMENSIONS (mm):
ADX40
SERVICE AND WARRANTY:
This microphone is under warranty for a period of 3 years from
any and all manufacturing defects. Should your microphone
fail in any way, please contact the Audix Service department
at 503-682-6933. A Return Authorization number is required
before returning any products
any and all manufacturing defects. Should your microphone
fail in any way, please contact the Audix Service department
at 503-682-6933. A Return Authorization number is required
before returning any products
.
CARE AND MAINTENANCE:
The ADX40 is manufactured to exacting specs with roadworthy construction.
However, the capsule is highly sensitive and should be handled with care.
Avoid extreme temperatures and be sure to store your microphone in the
pouch provided when not in use. Moisture of any kind can adversely affect
the sound and performance of your microphone.
However, the capsule is highly sensitive and should be handled with care.
Avoid extreme temperatures and be sure to store your microphone in the
pouch provided when not in use. Moisture of any kind can adversely affect
the sound and performance of your microphone.
***All specifications subject to change without notice.
www.audixusa.com
503-682-6933 Fax: 503-682-7114
Audix Corporation 9400 SW Barber St. Wilsonville, OR 97070
AUDIX WARRANTY REGISTRATION FORM
Please Check all that apply:
Male Female
Age:
Age:
Occupation:
Primary Instruments: Product to be used for:
18 or Under
Musician
Vocal
Pro live sound
19-25
Producer
Guitar / Bass
Pro recording
26-35
Sound Eng.
Drums
Home recording
36-45
Radio/TV
Keyboard
Rehearsal
46-55
Production
Brass
Installation
55 +
Other _______
Woodwinds
School
Strings
House of Worship
How did you hear about Audix?
Other ___________ Other ___________
Magazine Ad Online Ad
On-line Store Friend Do you own other Audix Products? Yes No
Salesman Other __________ Model(s) ________________________________
Have you visited the Audix website? Yes No
Please register your product online at www.audixusa.com or mail this form to:
Audix Microphones P.O. Box 4010 Wilsonville, OR 97070
Name:________________________________ Model:___________________
Company:_____________________________ Serial Number:_____________
Address:______________________________ Store:____________________
City:_________________________________ Store Location:_____________
Prov./State:___________ Zip:_____________ Purchase Date:_____________
Phone: ( )___________________________ Signature:_________________
Email:________________________________ Date:____________________