Netgear DUALBAND WLAN WNDAP360 N300 AP WNDAP360-PES 사용자 설명서
제품 코드
WNDAP360-PES
Introduction
12
ProSafe Dual Band Wireless-N Access Point WNDAP360
Rear Panel
Figure 2.
Table 1. Top Panel LEDs
Item
LED
Description
1
Power/Test Off
Power is off.
On (green)
Power is on.
Amber, then blinking
green
green
A self-test is running or software is being loaded.
During startup, the LED is first steady amber, then
goes off, and then blinks green before turning steady
green after about 45 seconds. If after 1 minute the
LED remains amber or continues to blink green, it
indicates a system fault.
During startup, the LED is first steady amber, then
goes off, and then blinks green before turning steady
green after about 45 seconds. If after 1 minute the
LED remains amber or continues to blink green, it
indicates a system fault.
2
Active
Off
No Ethernet traffic is detected or no link is detected.
On or blinking (green)
Ethernet traffic is detected.
3
LAN
Off
10 Mbps or no link is detected.
Amber
10/100 Mbps link is detected.
Green
1000 Mbps link is detected.
4
2.4
GHz
WLAN
Off
Wireless 802.11b/g/n (2.4 GHz) LAN is not ready or
no wireless activity is detected.
no wireless activity is detected.
On or blinking (green)
Wireless 802.11b/g/n (2.4 GHz) LAN is ready or
wireless activity is detected.
wireless activity is detected.
5
5
GHz
WLAN
Off
Wireless 802.11n/a (5 GHz) LAN is not ready or no
wireless activity is detected.
wireless activity is detected.
On or blinking (green)
Wireless 802.11n/a (5 GHz) LAN is ready or wireless
activity is detected.
activity is detected.
1
2
3
4
5
6
7